English
English
Español
Français

User Access


BITEC-StormBreaker-Sidebar
Van Mark Products - Sidebar Ad - July 2025 Rebates
DaVinci - Sidebar Ad - May 2024 Unmatched, Unlimited, Uncompromising
Metal Sales - Sidebar Ad
Gibraltar - Sidebar Ad - Metal Roofing
METALCON - Sidebar Ad SPAN - METALCON 2025
MuleHide-Sidebar-Q1
English
English
Español
Français

Question.

« Back To Roofers Talk
Author
Posts
September 10, 2010 at 11:42 a.m.

FL Roofer

Which would you say is the fastest method of running three tabs? Racking- forty five accross the roof, or column, up to the ridge and back down.

September 11, 2010 at 6:21 p.m.

robert

When i arrived in Florida in 1989 i had been running 3 tabs on 5 for years and hand nailing,i was introduced to senco staple guns and a lot of line popping there.I found it was faster to go up a rack with a staple gun or coil nailer and it was all about speed back then.We were getting paid very low and had a lot of metal to hang and bull to smear.

September 11, 2010 at 7:30 a.m.

TomB

$5 degrees.....Waaaayyyyy quicker/efficient


« Back To Roofers Talk
You must be logged in to reply to this topic.

Adams & Reese - Banner Ad - Trent Cotney - Roofing and the New Presidential Administration (podcast)
English
English
Español
Français

User Access


BITEC-StormBreaker-Sidebar
SRS - Sidebar Ad (En Espanol Page) - Roof Hub
Malco Tools - Sidebar Ad - Metal Benders
GAF Sidebar Spanish Program
MetalForming - Sidebar Ad - Generic
METALCON - Sidebar Ad - METALCON 2025
Sales Assist - Sidebar Ad - Build Present Close