IBC HIGH WIND CODE
« Back To Roofers Talk
Viewing 4
replies - 1 through 4
(of 4 total)
Author
Posts
May 26, 2011 at 9:37 p.m.
robert
State farm is refusing to pay for drip edge on shingle roofs, i need to document that the ibc high wind code requires the felt to be installed under the eave metal.As they are requesting this in writing from us.
June 4, 2011 at 1:37 p.m.
jimAKAblue
Robert Said: Still waiting for any help guys?
Typical thread Robert.
June 4, 2011 at 11:03 a.m.
robert
Still waiting for any help guys?
May 30, 2011 at 7:10 a.m.
jimAKAblue
I ran into this same problem. The IBC code that I read said that the drip edge is required only if it is required by the manufacturer's "approved" installation. I then could never find anyone that could show me where an "approved" installation was.
May 26, 2011 at 10:02 p.m.
CIAK
IBC install instructions don't accept as satisfactory manufacture specs?? B) :) :) B) Deep Down In Florida Where The Sun Shines Damn Near Every Day
Viewing 4
replies - 1 through 4
(of 4 total)
You must be logged in to reply to this topic.
