Counter flashing....

You guys never stop amazing me...thanks for the info!

I have spent 15 years roofing residential homes and I have never in my life used the term reglet. I had to google it.

Am I correct in assuming reglets come in all styles and shapes? Is a reglet only>>>

Old School installation technique was our standard, and to secure the c/f we used lead wedges. One time, on a federal building, we were confronted w/ a huge concrete wall, where the Thiokol caulk (and it was a great product) started to slump, and after ca>>>

Arrrrrrrr, rite , ye are ther , Mister C., Ole Jack's typin skills is alot like his kingnesses adobbin of tha grecian ther , it is for shure. Arrrrr, alittle here then alittle ther, ar ar ar ar ar ar ar.

YO HO HO AN A BUCKET OF THA BLACK!ARGH.:woohoo:>>>

If I've read ya right it's the ole hunt and peck . Sorta like when polly gets the cracker .>>>

Although my personal preference would be your way, I have done the straight version on a Red Roof Inn. Went through a lot of saw blades.

You might consider cutting the counter flashing into smaller lengths, 3'-4', to prevent buckling.>>>

Arrrrrr, ahoy ther Mister C, well shiver me monays ther , we says for shure. Ole Jack will search tha cranials depths of tha gray matter an have ye an answer for yer querry. It jus mite take Ole Jack a few to git it all on one page, as he aint tha best a>>>

Another reason I like the RCS , Ole Jack Legg Love the character man . Roofing humor at it's best. Jack I for one and I'm can't imagine I'm alone in this ..... Tell a little about how you came up with this character. I've been asked several times abo>>>

Arrrrrr, ahoy ther swabs, an ye also ther Big R, well shiver me timberlines therr we says for shure. In all me sailin of tha Seven Subds , we never thought we wood come to tha day that we wood as this, as much as it hurts , Ole jack must say that he concu>>>

[quote]Another simpler way is to just use a termination bar counter/flashing. It looks about the same, except you bend the flashing out at the top about half an inch at a 45 degree angle.

That certainly would NOT pass an inspection anywhere I hav>>>

one more thing, install vapor barrier at the highest point under the new counter...helps prevent condensation issues>>>

Used a tile saw to cut straight line around the chimney, lots of brick dust and makes a dirty mess on a brand new roof...make the cuts on the t/off phase

Remove excess loose mortar and blow out with an air gun. If there has been a lot of moisture over t>>>

Hi,

Same here. All three ways work.

Do it the way the customer wants it to look.>>>

That will work just fine. If you di it that way, just make sure and bned the top of the metal that you insert into the cut joint with about an 1/4 inch reverse bend as far as the break will bend it. When you drive it into the reglet it will bite like a>>>