Bitec - Color Selector

Each design has a specific pattern repeat, so in order to align the pattern and achieve maximum utilization of the roll, a certain portion of the repeat must be removed. The installer should expect to have a certain percentage of waste on each project. To help you approximate the material needed, the table on the right shows each pattern’s repeat length. You may have to remove up to and including 50% of this figure for alignment purposes, depending upon project requirements. Also, remember that you must provide a 6" minimum endlap.

The mineral granule colors shown on this piece are reproduced as a reference only, and as an aid in the selection of contrasting color schemes. The Actual product color may vary slightly from those shown. BITEC, INC. assumes no responsibility for any such color variance as shown versus the actual color. The purchaser should view actual available colors at their local BITEC distributor, or contact their local BITEC representative

Download Color Selector Now!

Share this: